Sorry I ment your cossie powered Focus. It looks like the cone hasn't got a heatshield, so it sucks (dirty) warm air.
Nah, no arch liner so there's a massive air flow from there, around the headlight and flowing from the upper grill. Heat soak never been a problem with my car
Throttle body sorted, few more bits and bobs before in goes into bodyshop next week to have bonnet painted and the other quarter repainted. Smallest spot of rust on the inner arch and the previous owner had it touched up at some point and his bodyshop painted over the original Armourfend Got a new extended arch Armourfend to go on once its back to match the other side after that had its paint job. Should be all minty mint then Also got the Mrs a nice new front splitter, since the original was a bit tatty.
So chuffed, Mark's finally finished my beam. He's got a busy schedule, but he's added my solid mounts and my handbrake cable brackets next to the main beam adjusters. So top job all round! Can't wait to fit it Friday. Cheers Mark!!!:top:
Some quick piccies after the body shop (some slight polish marks still there). Bonnet repainted and the quarter repainted to match the other. Inner arch had some slight rust patches which have been sorted. Nice extended arch Armourfend now in place too. Looking quite mint now
looks absolutly mint there mate. But the gap between the front fender and bonnet looks like nothing? Hope there is no major gap on the other side
New toy came today, so got bust fitting most of it this evening. Amazing craftmanship! Will take more pics when I'm done fitting it all. Thanks MK Motorsport :top:
Finished fitting the beam. Drove to the top of my drive ok and didn't fall apart Need to sort insurance out to take for a proper spin.
Since having the new beam, I had an issue with the original handbrake cable mounts being a little shorter than before to make room for the rosejoint adjuster. So had to cut the cable a little. Found this neat little billet clamp which has worked a treat. Normally used for throttle cables on go karts :top:
Got busy today. But one of the AN fittings had small hairline cracks so wasn't sealing, resulting in a fuel leak. So ordered another and she should be good to go [/URL