bumper demonteren

richard b · 17 aug 2008

weet ook iemand een howto van hoe je de voorbumper demonteerd van een MKII.
Volgens mij staat er ook 1 op het forum maar kan hem niet vinden.

richard b · 20 aug 2008

bumper

niemand hier die dat weet.

write2glenn · 20 aug 2008

ik ben bang van niet . Wat ben je van plan?

skyflyer · 20 aug 2008

write2glenn zei:

ik ben bang van niet . Wat ben je van plan?
Klik om te vergroten...

Volgens mij om zn onderlip dat hij gespoten heeft te bevestigen?
Kan je daarvoor niet beter een brug oprijden? Bij het afhalen van je bumper heb je meer kans hem te beschadigen...
Als je een hefbrug oprijd, kan je er makkelijker aan.

SkyFlyer

rodders · 20 aug 2008

heb er eentje in het engels, hoop dat je engels goed is anders zal ik het wel vertalen:

Start by opening the bonnet and remove the key as you will need the grill off.
Remove the right headlight by undoing the screw on the top of the headlight unit.
Useing a long screwdriver, press down on the two latches at the back bottom of the light unit. This will release it and then it can be pulled away from the car. Don't forget to unplug the loom though! - Slide a smallish flatheaded screwdriver in the locking latch of the plug and give a firm pull to get it of. Repeat with the Left Side Headlight.

Above the grill there is a slam pannel cover. Either side of this there is a plastic screw that is only in there as a popper to hold another little piece of plastic, that also holds the top of the bumper together like a rivet but Removable.
Gently unscrew this with the correct size screwdriver so as not to damage the plastic on the head. When free, remove the other bit of plastic. Together these are quite a clever invention however - i like to call them Scrivets.

Once the slam cover is off, you will see another 4 of these (Scrivets), these hold the top of the grill and need to come out at this point. Around the bottom of the grille are little catches that when pushed in grip the bumper, they will need a little pressure to straighten them enough to pull them out from the bumper 'sockets'. ALSO either side of the locking barrel for the bonnet release is two plastic lugs that when pulled apart the grille will finally be free. Putting the grille back is in reverse and will be fine as long as it is the same grille or another OEM one. LX/Sport/Zetec/Ghia/Titanium/ST= All Fine.

WARNING Fitting aftermarket grills will probably disturb the working of this lock mechanism but can be adjusted by ford for between £50 and £80 for a pin that can secure the part between the latch and the key barrel.

Once the grill is removed, you will see an array of clips holding on the bumper along the front lip - between the headlights where the grille was. Leave these for now, but take a note of where they are.

Get a jack and axel stands as the car's front will be lifted up for a while - Time depending on the reason you are taking the bumper off. Once up, take the front wheels off to give you maximum space as you will need to get a screwdriver and you're arm in there.

Useing a starshapped screwdriver (can't recal size) remove as many of the screws holding the inner wheelarch lineing as needed to access the three screws along the top inside of the bumper - these are the screws connecting the wheel arch to the bumper. There are three on each side of the car. They are very tight so you need to use a bit of force. One is imediately when you move the wheelarch cover and the other two are below where the headlight was however you can only reach them from the wheelarch. + To do this you will need a size 10 (i think)socket with an extension if possible. I used a scredriver with this part on the end. RARE TOOL...

Under the car along the forward edge of the bumper you will probably have noticed more scrivets, these need to be removed like the above ones and for those of you with fog lights, just disconect the bulb holder from the unit, they can dangle with the bulbs in as they will be ok.

Back to the clips on the top - working from the sides inwards, just release them slowly one at a time and when you come to the last one make sure you are supporting the bumper as after undoing the last one, it is free from the car.

The new bumper will go on the same way as long as it is FORD, otherwise consult you bumper maker or instructions/fitting guide if different.
Klik om te vergroten...

richard b · 20 aug 2008

bumper

Rodders super gedaan.

Nee mijn engels is zeer goed(werk)
Geen enkel probleem bedankt.

rodders · 20 aug 2008

okay, geen probleem dan, en veel plezier ermee!

Forums

bumper demonteren

richard b Forumlid

richard b Forumlid

write2glenn Forumlid

skyflyer Forumlid

rodders Forumlid

richard b Forumlid

rodders Forumlid

Deel Deze Pagina

Focusclub.nl

Huisregels

Nuttige Zoekopdrachten

bumper demonteren

richard b Forumlid

richard b Forumlid

write2glenn Forumlid

skyflyer Forumlid

rodders Forumlid

richard b Forumlid

rodders Forumlid

Deel Deze Pagina